Repair the leakage of the shower head to the ball Solut […]
Repair the leakage of the shower head to the ball
Solution: First, unscrew the shower head from the steering ball ring, find the O-ring inside or a similar seal and replace it, then turn the shower head back into place.
Shower head handle junction leakage
Solution: Select the appropriate shower hose and faucet according to the standard and replace it with the rubber ring and reinstall it. First, use the strap tie pliers to unscrew the shower head handle from the hose. Clean the threads on the handle of the shower head and apply a special adhesive for the water pipe around or tie the raw tape. Then screw the shower head back and tighten to remove the remaining adhesive and raw tape.
The leaking head of the shower head may also be formed by sand or sediment in the shower head.
Solution: Unscrew the shower head. If necessary, soak the parts with vinegar and wipe the parts. Take care to prevent them from being scratched. If the shower head is adjustable spray, carefully inspect all movable parts to see if there are excessive signs of wear. If the rotation credentials do not move smoothly, or if the internal cam is broken, replace the entire shower head.
Shower head fine water becomes thick and thin
Solution: Rotate the shower head. If it is not enough, turn a small round cap in the center of the shower head with a screwdriver, rinse the sprinkler head with water, and brush the shower hole with a toothbrush. Just restore it.